MATERIAL
Reinforced and stabilised polyamide
Oils and greases resistant.
MAIN INSERT
Zinc plated steel insert with smooth through-hole (H10 tolerance).
SIDE INSERT
Brass right through threaded bush.
SIDE HANDLE
Revolving handle M144 (pag. M-08).
For fixing system, or execution of keyway or square holes, please refer to the technical notes attached to the catalogue.
SPECIAL REQUEST
• It’s possible to supply the inserts with d1 bore by customer design, on request and for quantities.
• It’s possible to supply the inserts in different material and treatment-finishes, on request and for quantities.
• It’s possible to supply the products with colours (reduced range) as shown in the table at page D-19, on request and for quantities.
Version with zinc plated insert and H10 tolerance bore
• It’s possible to supply the inserts with d1 bore by customer design, on request and for quantities.
• It’s possible to supply the inserts in different material and treatment-finishes, on request and for quantities.
• It’s possible to supply the products with colours (reduced range) as shown in the table at page D-19, on request and for quantities.
ATTENTION: BORE D1 (H10 TOLERANCE) COULD BE PRODUCED BY REQUEST, WITH 50 PIECES MINIMUM.
Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).
Version with black-oxide insert and H7 tolerance bore
Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).
ATTENTION: REPLACE THE TWO PLACES IN THE CODE .. WITH THE HOLE DIAMETER REQUIRED - 50 PIECES MINIMUM
Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).
A.R. = By request
Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).