D214

MATERIAL

Reinforced and stabilised polyamide

Oils and greases resistant.

SURFACE

Satin.

COLOUR

Black (RAL 9011).

CENTRAL CAP

Grey polyamide (RAL 7035 cod. 13).

ALTERNATIVE CAP COLOUR

Orange (RAL 2004 cod. 02)

Blue (RAL 5015 cod. 07)

Yellow (RAL 1021 cod. 10)

Red (RAL 3000 cod. 16)

Green (RAL 6024 cod. 17)

Black (RAL 9011 cod. 01)

MAIN INSERT

VERSION TD: ZINC PLATED STEEL INSERT WITH SMOOTH THROUGH-HOLE (H10 TOLERANCE).

VERSION TM: ZINC PLATED STEEL INSERT WITH THREADED THROUGH-HOLE (6H TOLERANCE).

For fixing system, or execution of keyway or square holes, please refer to the technical notes attached to the catalogue.

SPECIAL REQUEST

It’s possible to supply the inserts with d1 bore by customer design, on request and for quantities.

• It’s possible to supply the inserts in different material and treatment-finishes, on request and for quantities.

• It’s possible to supply the products with orange colours , on request and for quantities. (RAL 2004 cod. 02).

Version TD with zinc plated insert and H10 tolerance bore.

It’s possible to supply the inserts with d1 bore by customer design, on request and for quantities.

• It’s possible to supply the inserts in different material and treatment-finishes, on request and for quantities.

• It’s possible to supply the products with orange colours , on request and for quantities. (RAL 2004 cod. 02).

ATTENTION: BORE D1 (H10 TOLERANCE) COULD BE PRODUCED BY REQUEST, WITH 50 PIECES MINIMUM.

Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).

Version TM with zinc plated insert and 6H tolerance threaded bore .

Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).