D454

MATERIAL

Reinforced and stabilised polyamide

Oils and greases resistant.

SURFACE

Satin.

COLOUR

Black (RAL 9011).

CENTRAL CAP

Grey polyamide (RAL 7035 cod. 13).

ALTERNATIVE CAP COLOUR

Orange (RAL 2004 cod. 02)

Blue (RAL 5015 cod. 07)

Yellow (RAL 1021 cod. 10)

Red (RAL 3000 cod. 16)

Green (RAL 6024 cod. 17)

Black (RAL 9011 cod. 01)

MAIN INSERT

Zinc plated steel insert with smooth through-hole (H10 tolerance).

HUB

Hollow underneath hub.

For fixing system, or execution of keyway or square holes, please refer to the technical notes attached to the catalogue.

SPECIAL REQUEST

• It’s possible to supply the inserts with d1 bore by customer design, on request and for quantities.

• It’s possible to supply the inserts with threaded d1 bore, on request and for quantities.

• It’s possible to supply the inserts in different material and reatment-finishes, on request and for quantities.

Version with zinc plated insert and H10 tolerance bore

• It’s possible to supply the inserts with d1 bore by customer design, on request and for quantities.

• It’s possible to supply the inserts with threaded d1 bore, on request and for quantities.

• It’s possible to supply the inserts in different material and reatment-finishes, on request and for quantities.

ATTENTION: BORE D1 (H10 TOLERANCE) COULD BE PRODUCED BY REQUEST, WITH 50 PIECES MINIMUM.

Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).

Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).