D779

MATERIAL

Reinforced and stabilised polyamide

Oils and greases resistant.

SURFACE

Satin.

COLOUR

Black (RAL 9011).

MAIN INSERT

Zinc plated steel insert with smooth through-hole (H10 tolerance).

SIDE INSERT

Brass right through threaded bush.

SIDE HANDLE

Revolving handle M144 (pag. M-08).

For fixing system, or execution of keyway or square holes, please refer to the technical notes attached to the catalogue.

SPECIAL REQUEST

• It’s possible to supply the inserts with d1 bore by customer design, on request and for quantities.

• It’s possible to supply the inserts in different material and treatment-finishes, on request and for quantities.

• It’s possible to supply the products with colours (reduced range) as shown in the table at page D-19, on request and for quantities.

Version with zinc plated insert and H10 tolerance bore

• It’s possible to supply the inserts with d1 bore by customer design, on request and for quantities.

• It’s possible to supply the inserts in different material and treatment-finishes, on request and for quantities.

• It’s possible to supply the products with colours (reduced range) as shown in the table at page D-19, on request and for quantities.

ATTENTION: BORE D1 (H10 TOLERANCE) COULD BE PRODUCED BY REQUEST, WITH 50 PIECES MINIMUM.

Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).

Version with black-oxide insert and H7 tolerance bore

Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).

ATTENTION: REPLACE THE TWO PLACES IN THE CODE .. WITH THE HOLE DIAMETER REQUIRED - 50 PIECES MINIMUM

Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).

A.R. = By request

Dm = It’s possible to increase the hole, by boring, until Dm (enlarge).